Repair dents and scratches on hardwood floors to retain the fine appearance of wood flooring otherwise they may detract from the natural beauty of the wood. It solely depends on how bad the scratch is.

Repair Dents and Scratches based on the Finishing of your Floor

There are various kinds of floor finishes, so, it’s crucial to know which one was used on yours so you can match them. The most common choices are Varnishes made of oil-based polyurethane, hard wax coating, and water-based polyurethane.

Identification of the fact that whether it is Repairing Fine Superficial or it is a Deep Huge Scratch

You may use a simple DIY solution of white vinegar and olive oil to cure a little fine surface scratch. Mix the two together and use fine wire wool to apply to fine scratches, then wipe away the mixture with a cotton cloth.

Also check: Repair vs Replacement | Expert Advice from Wood Floor Scratch Repair Professional

Getting Rid of Small Scratches

You may use a simple DIY solution of white vinegar and olive oil to cure a little fine surface scratch. Mix the two together and use fine wire wool to apply to fine scratches, then wipe away the mixture with a cotton cloth.

• First and foremost, the step is to clean the scratch area with soft cotton dipped in water.

• Rinse the cleanser well. After washing the scratched area, softly rinse and wipe away any surplus cleanser using a towel. Remember, the towel should be dampened with warm water and a little dash of fairy liquid water.

• Fill in the scratch with a tinted wax stick (if the wax is too hard, gently melt it with a flame). Then, enter the wax down into the wood scratch using a plastic card or knife).

• Buff the scratch using a clean cotton towel, rubbing back and forth over the scratched area to remove any excess wax, and buff until it matches the existing wax.

• If still the matching is required then repair with the original finish.

Parts of the Stained or Coated Floor should be Refinished

• Use a scouring pad and mineral spirits to remove filth from a damaged coated floor coat.

• Gently massage the scrape, using fine wire wool. Allow it to dry completely before wiping it away with a clean cotton cloth.

• Sand down the area with 240-grit sandpaper to the original wood finish.

• If necessary, use a tinted stain that complements your floor. Allow 30 minutes for the recipe to dry before applying a new layer of polyurethane using a rollover or brush. between layers, let it dry.

Refinishing of whole wood Floor to remove dents and scratches

This is a sensible option if your whole floor is covered with scratches and dents.

On all wood floors, thorough sanding eliminates all scratches. If you have a genuine wood surface on an engineered wood floor, be sure it hasn’t been sanded too many times. Natural wood can only be sanded once or twice before it becomes unusable.